From wikistone
Jump to: navigation, search

CIR (committed access rate) - Guaranteed bandwidth from the ISP LAR (local access rate) - What your equipment can actually handle LMI - language between your routers and frame relay switches DLCI - MAC Address is to Ethernet as DLCI is to Frame Relay. Leave on a local DLCI number, travel through the cloud, and exit on the other end's DLCI. Just like at an airport gate. DLCIs are locally significant. PVC - a virtual dedicated link through the cloud between locations that has its own CIR

Multipoint design: all routers are on one subnet Point-to-Point design: all pairs of routers are on different subnet (no split horizon issues) //broadcast is enabled by default In a multipoint design, all routers are on the same subnet, you have to statically map every connection between all of the routers, much like configuring a static route There are two frame-relay encapsulation standards: IETF and cisco, make sure both routers are using the same Modern routers auto-detect the LMI type. If the data-link layer is down, then there may be a LMI type mismatch.

  1. show frame-relay lmi

Frame-relay switch (DCE switch): (config)frame-relay switching //makes the device a frame-relay switch (config-if)no ip address //frame relay switches operate at layer 2, so they don't need an IP address (config-if)encapsulation frame-relay [MFR | ietf] //enables frame relay on that interface, and optionally specify the encapsulation standard (config-if)clockrate <#> //provides clocking signals to the connected Frame Relay routers, which are set up as DTE devices (config-if)frame-relay intf-type dce //make it a DCE interface (config-if)frame-relay route <incoming DLCI #> interface <outgoing interface> <outgoing DLCI #> The frame relay switch does not have DLCIs of its own.

  1. show frame-relay route

Communication between two Frame Relay switches: Exactly the same as above, except: (config-if)frame-relay intf-type nni Equal clocks must be set on both ends Frame relay switching is also to be configured

DTE switches: by default a router is considered to be a DTE device Point-to-Multipoint: (config-if)encapsulation frame-relay (config-if)frame-relay map ip <remote ip address> <local dlci number to get there> [broadcast] //similar to configuring a static route IARP: does the above mapping so you don't have to (obtain L3 from L2)

Point-to-Point: (config-if)encapsulation frame-relay (config-subif)frame-relay interface-dlci <#> //no map statement required, because it's a point-to-point Sub-interfaces: a single physical interface but multiple sub-interfaces to represent the multiple PVC’s (Permanent Virtual Circuits) Encapsulation and no shut is set on the physical interface, not subinterfaces (config)int s0/1/0.102 point-to-point (config-subif)frame-relay interface-dlci <#>

  1. show frame-relay map
  2. show frame-relay pvc //more detailed version of map