From wikistone
Jump to: navigation, search
(Created page with "* all ports same speed / duplex * all ports on same VLAN or all trunk/tag (with same VLANs allowed) * will not form if a port in the bundle is a SPAN destination * L3 EtherCha...")
 
 
Line 23: Line 23:
 
sw(config-if)# channel-group # (mode [desirable | auto | active | passive])
 
sw(config-if)# channel-group # (mode [desirable | auto | active | passive])
 
sw(config-if)# channel-protocol [lacp | pagp]</nowiki>
 
sw(config-if)# channel-protocol [lacp | pagp]</nowiki>
 +
 +
Cisco show:
 +
<nowiki>
 +
sw# sh etherchannel # </nowiki>
  
 
.
 
.
 
[[Category:Networking]]
 
[[Category:Networking]]
 +
[[Category:Cisco]]

Latest revision as of 16:31, 23 November 2012

  • all ports same speed / duplex
  • all ports on same VLAN or all trunk/tag (with same VLANs allowed)
  • will not form if a port in the bundle is a SPAN destination
  • L3 EtherChannels get an IP on the logical port only

PAgP: Port Aggregation Protocol (Cisco proprietary)

  • on: force EC using PAgP
  • desirable: active negotiation
  • auto: passive negotiation (other side must be desirable for link to form)

LACP: Link Aggregation Control Protocol

  • on: force EC using LACP
  • active: active negotiation
  • passive: passive negotiation (other side must be active for link to form)


Cisco config:

sw(config)# int port-channel 1
! set desired characteristics
sw(config-if)# bandwidth #
! set bandwidth used for calculating STP/etcetera
sw(config-if)# channel-group # (mode [desirable | auto | active | passive])
sw(config-if)# channel-protocol [lacp | pagp]

Cisco show:

sw# sh etherchannel # 

.