From wikistone
(Created page with "Monitor all traffic on port 25: tcpdump -vv -x -X -s 1500 -i eth1 port 25 * -vv : More verbose output * -x : When parsing and printing, in addition to printing the headers of...") |
|||
| Line 1: | Line 1: | ||
| + | ==Text Dump== | ||
Monitor all traffic on port 25: | Monitor all traffic on port 25: | ||
| Line 5: | Line 6: | ||
* -x : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet. | * -x : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet. | ||
* -X : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet (minus its link level header) in hex and ASCII. This is very handy for analysing new protocols. | * -X : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet (minus its link level header) in hex and ASCII. This is very handy for analysing new protocols. | ||
| − | * -s 1500: Snarf snaplen bytes of data from each packet rather than the default of 68. This is useful to see lots of information. | + | * -s : 1500: Snarf snaplen bytes of data from each packet rather than the default of 68. This is useful to see lots of information. |
| − | * -i eth1 : Monitor eth1 interface | + | * -i : eth1 : Monitor eth1 interface |
| + | |||
| + | ==File Dump== | ||
| + | tcpdump -i [interface] -s 0 -w [file] | ||
| + | * -s : bytes per packet to capture, default is 68 L3 bytes (96 L2), set to 0 to get all bytes in the packet | ||
Revision as of 13:13, 14 May 2014
Text Dump
Monitor all traffic on port 25:
tcpdump -vv -x -X -s 1500 -i eth1 port 25
- -vv : More verbose output
- -x : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet.
- -X : When parsing and printing, in addition to printing the headers of each packet, print the data of each packet (minus its link level header) in hex and ASCII. This is very handy for analysing new protocols.
- -s : 1500: Snarf snaplen bytes of data from each packet rather than the default of 68. This is useful to see lots of information.
- -i : eth1 : Monitor eth1 interface
File Dump
tcpdump -i [interface] -s 0 -w [file]
- -s : bytes per packet to capture, default is 68 L3 bytes (96 L2), set to 0 to get all bytes in the packet